Fur type filter
-
Sometimes I wish there was a way to filter by fur type (short/smooth vs. shaggy vs. little/none etc.) It would really help when there's just a giant flank right up against the camera, and it's too close to even properly figure out pattern or body build.
Posted
-
by davidbygott moderator
Fortunately there are only a few species who stand close to the camera and are tall enough to block the field of view. Mostly they are:
wildebeest (grey-brown, often with darker vertical stripes),
hartebeest and eland (both tan; eland has dark stripe along belly centre and sometimes thin white vertical stripes)
topi (reddish brown with grey patches on shoulder or hip)
buffalo (black or dark grey, coarse or sparse hair)
elephant (grey, wrinkled, mostly hairless)
zebra (obvious b&w stripes).
IMHO at least 95% of cases will be one of the above.
In the case of warthog, hyena, lion, gazelles and impala, usually the camera (mounted about 1 metre above ground) can see over their backs even when they are very close.Posted
-
Thanks for the tutorial, that does help a lot. 😃
Posted
-
by mecurtin in response to davidbygott's comment.
You should make this one of the "pinned" posts. It's a really handy reference guide we could all use!
Posted
-
by LanceSnider
Ah, that's super helpful, thanks!
Posted
-
by hayvel
This implala is too tall, or the camera too low ... 😉
Posted
-
by davidbygott moderator
Yeah well, perhaps I exaggerated how small they are. And there is probably some variation of camera height too.
Posted
-
by hayvel
David, last season you (or Ali ? Margaret ?) send us a link to a picture showing the size of animals. I add a red spot at 1 metter approx.
If it can help ....
http://hayvel.com/serengeti-animals.jpg
Posted
-
by dolphinate
Neat! I did not realise the secretary bird or the bustard were so tall.
Posted